Metric or inch threads? How to identify the correct system
Identify a thread by its system, diameter, pitch and geometry. Appearance, wrench size or alignment with ruler marks does not establish compatibility. Measure an unknown part and compare the complete result with the appropriate standard.
Metric threads: diameter and pitch in millimetres
M8 × 1.25 identifies an 8 mm nominal diameter and a 1.25 mm pitch, the distance between adjacent threads. An added length can produce a designation such as M8 × 1.25 × 30. See Bolt Depot's measurement notation guide.
One diameter can have several pitches. Standard M8 pitch is 1.25 mm, while 1.0 mm is a fine-pitch option. The metric pitch table illustrates why an enquiry about an unknown part should include pitch.
UNC and UNF: threads per inch
Unified threads use inch diameters and TPI, or threads per inch. UNC is the coarse series and UNF the fine series. They are specific families, not names for every inch thread.
A 5/16-18 UNC thread has a nominal diameter of 5/16 inch and 18 threads per inch. Its diameter is 7.9375 mm, close to M8, but its pitch converts to approximately 1.411 mm. Standard M8 pitch is 1.25 mm. Similar diameters therefore do not make these threads interchangeable.
The thread angle alone is not decisive
Common ISO metric and Unified UNC/UNF threads both have a 60° profile angle. Compatibility requires the complete standard, not one feature.
Pipe connections also include BSP and NPT. BSP has a 55° profile, while NPT has a 60° profile. Parallel or tapered form and sealing arrangement matter too. Swagelok's identification guide distinguishes thread standards from the complete connection geometry. A 1/4 inch pipe size does not mean a 6.35 mm outside thread diameter.
Checking an unknown thread
- Look for a drawing, packaging designation or parts list.
- Measure diameter using a suitable instrument. For an external thread, measure across the crests; actual and nominal dimensions may differ.
- Check pitch with a gauge and establish whether it is specified in millimetres or TPI.
- For pipe connections, establish parallel or tapered form and the sealing arrangement.
- Compare all the data against the appropriate product family documentation.
Identification measurements are not a full thread tolerance inspection. If the results are ambiguous, do not select a near match using a single dimension. Provide photographs, measurements and application details to the supplier.
Why markings and a ruler are insufficient
A property class marking does not directly establish thread standard or pitch. Some fasteners have no readable marking. A ruler gives an approximate measurement, not a rule for identifying metric threads by alignment with millimetre marks.
There is no fixed number of turns after which every incompatible thread jams. Stop when resistance or uncertainty appears and verify the parts. Forcing the fastener can damage an expensive tapped component.
Preparing the enquiry
Record nominal size or measured diameter, pitch in mm or TPI, known standard, length, head and application. For pipe connections, add the fitting designation and sealing information. Mark unresolved parameters as unknown.
This guide explains thread systems. Send your information to Śrub-Top to narrow down variants and check availability.
Reviewed and updated on 12 October 2026.
